There are a lot of blisters on the surface of rubber O-rings in the later stage of production, which not only greatly reduces the appearance of the product, but also affects the performance of the product. So what are the reasons for the bubbles? What are the solutions?
One, the reason for rubber O-ring equipment and mold Cause analysis.
(1) The high temperature control of the equipment causes the mold temperature to rise and the flow time of the rubber die to shorten.
(2) There is damage and dirt on the mold surface, which will affect the fluidity of the rubber.
(3) The location of the mold exhaust lines and holes is not reasonably distributed, causing the exhaust to be affected.
2. Solution
(1) Improve the temperature control sensor system of the equipment, so that the temperature in the mold is in a balanced state.
(2) Repair the damaged surface of the mold and clean the dirt on the mold regularly.
(3) Improve the position layout of mold exhaust lines and holes to enhance the effectiveness of exhaust.
Two, rubber O-ring raw material factors
Cause analysis
(1) The moisture and volatilization in natural rubber do not meet the standard requirements.
(2) Other auxiliary materials are damp, resulting in an increase in moisture.
Solution
(1) After cutting the natural rubber, the rubber can be bake appropriately to reduce the moisture and volatilization in the rubber.
(2) Auxiliary materials should be stored in a dry and ventilated place. In the rainy season, pay attention to moisture-proof measures.
