1.Check the piston, cylinder tube, and the relevant surface where the guide sleeve is installed, and make sure that it is clean, free of burrs, and edges.
2.The installation tools are required to be smooth, without edges, and sharp corners to ensure that the seals will not be damaged in any form during the installation process (Othello's OTH-0003 hydraulic seal special installation tool is recommended).
3.During installation, a small amount of grease can be drawn on the surface of the seal and the cylinder barrel to facilitate the installation, but no grease should be left between the rubber elastomer and the sliding seal ring, otherwise it will affect the sealing performance.
4.Whether it is vertical or horizontal installation, the coaxiality between the piston and the cylinder should be maintained. Excessive eccentricity is likely to damage the seal.
