KNOWLEDGE

Home > KNOWLEDGE > Content
X-Ring Quad Rings
Apr 24, 2018

X ring.jpg

A double-acting four lip seal for static and dynamic applications. Quad-Rings (also known as X-Rings) are available in a wide range of elastomer compounds. Provides higher seal efficiency and lower friction than conventional O-Rings.


Avoiding Spiral Twist

To minimize breakaway friction, an O-Ring groove must be wide enough to allow rolling or twisting of the seal. In the long stroke of a reciprocating seal application, this twisting action can strain and eventually tear the rubber, causing a failure mode known as the spiral twist.

To prevent spiral twist, the Quad-Ring seal’s four-lobed configuration is designed to withstand the distortion and extrusion often caused by high or pulsating pressure. To accommodate these forces, a Quad-Ring seal uses a narrower groove than a comparable O-Ring seal.


No Parting Line on Sealing Surface

Unlike O-Rings, where partitioning lines are on the

sealing surface, Quad-Rings seal’s parting lines lie between the lobes, away from the sealing surface. This design eliminates the problems of leakage resulting from a parting line’s irregular surface


Longer Seal Life

Because less squeeze means less friction with the four-lobe design, seals last longer. This means equipment in which the Quad-Ring seal is installed will operate longer and require less maintenance.








Copyright © Tianjin SVKS Technology & Development Co.,Ltd All Rights Reserved.Tel: +86-13821913077